Fujikura Speeder NX Green Shaft

IMPORTANT: Fujikura shaft must be assembled with head or an adapter, cannot be sold individually. please use our free installation to assemble this shaft ( FREE INSTALL )

IMPORTANT: Please contact us if your adapter is not listed in this listing

Introducing Fujikura Speeder NX Green Shaft, Following the success of Fujikura NX Series shaft ( blue ), 

Adopting Fujikura's original 3D motion capture system "enso" and "VTC" that precisely controls torque distribution, the first generation "NX" evolved from 2D to 3D design.

"SPEEDER NX GREEN" is based on such a first-generation model, and is designed with a smooth EI distribution with few undulations. On the other hand, the difference in torsional rigidity between the middle part and the hand side is increased to create a shaft that can be turned flexibly.

In addition, by increasing the bending rigidity on the tip side, it is possible to push the impact and further increase the ball speed. It is a shaft that has high straightness and achieves a strong trajectory.

ENSO

Fujikura's original 3D motion capture system enables club motion analysis during the swing. Fujikura was able to find a connection between the swing process and the result of the ball trajectory.

VTC

The torque distribution is controlled more precisely with the medium tone EI distribution.

By increasing the torque at the tip and hand, it is possible to achieve both high initial velocity and high trajectory with ease of swinging in medium tone.

As a result, it was found that the rate of increase in the loft angle toward impact increased, resulting in <face angle closed> and <incident angle upper blow>.

ABOUT THIS PRODUCT LISTING

- Available in 4 models based on weights

- OFFICIAL RELEASE DATE OCTOBER 9, 2022

AVAILABLE ADAPTER